Serial Number:
88733860
Mark:
DOTTIE L H DOTTIE
Status:
Registered
Status Date:
08-18-2020
Filing Date:
Registration Number:
6128744
Registration Date:
08-18-2020
Nuts of metal, bolts of metal, screws of metal, anchors, self-tapping bushings of metal, chains of metal, metal fastener clamps, tubes of metal, metal tube nipples and caps, metal expanding sleeves for affixing screws, metal junction sleeves for non-electric cables, cable junction sleeves of metal, metal tube couplings and pipe connectors and couplings, metal drive pins anchors, bar hangers and parts and fittings therefor made of metal for electrical fixtures/housing, bar hangers and parts and fittings therefor made of metal for lighting fixtures, sheet metal plates, steel rods, metal staples for construction or industrial use, metal washers, and non-electrical wire of common metal, safety plates in the nature of armour plate of metal for building, all-purpose metal straps, metal clamps, metal ground clips and crimp sleeves, threaded metal conduit, metal conduit and pipe fittings, metal gaskets for plumbing and fastening use and covers, metal pipe supports, metal roof flashings, and metal plumber's tape in the nature of metal straps; metal fasteners Insulating and rubber materials, namely, adhesive tapes for industrial and commercial use, including duct tape, electrical PVC tape, insulating tapes, namely, friction tape, masking tape, pipe wrap tape for insulation, insulating tapes, namely, rubber tape, shock absorbent insulation pads in sheet form for use in further manufacturing and insulated pipe supports, duct seal in the nature of non-permanent adhesive putty, expanding foam being polyurethane foam for insulating, silicone sealant; Sleeves of rubber for protecting parts of machines, insulating sleeves for power lines and water heaters, identification sleeves of rubber for tubes
Mark Description:
The mark consists of a stick figure comprised of metal hardware parts, outlined in black and shaded in white, and imposed over a yellow circle outlined in black. A washer that represents the head of the stick figure contains the stylized black letters "L H" in the upper portion and "DOTTIE" in its lower portion, from which two hex nuts resembling ears protrude in an upward left and right orientation, the torso resembles a threaded screw with its top nut resembling its neck and extending at the bottom end into two threaded screw legs ending in nuts that resemble its feet, and opposing tapered planar arms. A rectangular yellow label outlined in black with rounded edges contains the word "DOTTIE" in black font, extending at about a 45 degree angle from the upper left side of the yellow and black circle.
Class:
Rubber
Type of Mark:
Trademark
Published for Opposition Date:
06-02-2020
Owner:
Mark Drawing Status:
Design plus Words, Letters, and/or Numbers
Abandon Date:
N/A
Business Name:
APEX JURIS PLLC
Correspondent Name:
